FRENDEESIT

Mole
trap

Thank you for choosing Kilit. Here is how to find the right tunnel, set your copper traps and activate your lifetime guarantee.

Read the guide Activate my guarantee Buy on Amazon PDF guide
Kilit mole trap kit: copper traps, stakes, flags, twine, key and gloves

In your box

Pack of 10

10 copper wire traps (15 cm), 10 steel stakes, 12 yellow flags, 6 m of twine, 1 setting key, 1 pair of gloves.

Pack of 5

5 copper wire traps (15 cm), 5 steel stakes, 6 yellow flags, 3 m of twine, 1 setting key, 1 pair of gloves.

Before you start

The secret: the right tunnel

The foot test to find an active tunnel
  1. In the evening, flatten the tunnels with your foot, between two fresh molehills.
  2. The next day, look: a tunnel that has been pushed back up is active. That's where you set the trap.

Always set the trap in the tunnel, never in the molehill itself.

Set up in 4 steps

The 4 steps: locate, set, place, mark
  1. Locate. Open the active tunnel by hand or with a small trowel, and clear the soil blocking it.
  2. Set. Open the jaws with the key, slowly and straight: pressing at an angle bends the jaw.
  3. Place. Slide the set trap into the tunnel, tie the twine to the trap and the stake, push the stake in next to it.
  4. Mark. Put in a yellow flag and close the hole with the clod so that no light or air gets in.

Checking and care

Every day

Check your traps. The flag helps you find them, and avoid them when mowing.

Nothing after 3 days?

Move the trap to another active tunnel: repeat the foot test.

At the end of the season

Rinse and dry the traps before storing them. Copper doesn't rust: they work again next season.

Precautions

Activate your lifetime guarantee

A Kilit trap breaks or stops working? We replace it. Fill in this form, it takes 1 minute.

Your data is only used to manage your guarantee. Privacy

A question?

Write to us, we reply within 24 hours.

Contact us